激光打印机常见卡纸故障及解决方法（Common jam fault and solution in laser printer）.doc

下载文档 降价啦

12
0
约1.49万字
约 11页
2017-09-23 发布于河南
举报
版权申诉
保障服务

激光打印机常见卡纸故障及解决方法（Common jam fault and solution in laser printer）.doc

1、本文档共11页，可阅读全部内容。
2、原创力文档（book118）网站文档一经付费（服务费），不意味着购买了该文档的版权，仅供个人/单位学习、研究之用，不得用于商业用途，未经授权，严禁复制、发行、汇编、翻译或者网络传播等，侵权必究。
3、本站所有内容均由合作方或网友上传，本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺！文档内容仅供研究参考，付费前请自行鉴别。如您付费，意味着您自己接受本站规则且自行承担风险，本站不退款、不进行额外附加服务；查看《如何避免下载的几个坑》。如果您已付费下载过本站文档，您可以点击这里二次下载。
4、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等，请点击“版权申诉”（推荐），也可以打举报电话：400-050-0827(电话支持时间：9:00-18:30)。

激光打印机常见卡纸故障及解决方法（Common jam fault and solution in laser printer）

激光打印机常见卡纸故障及解决方法（Common jam fault and solution in laser printer） Common jam fault and solution in laser printer 1) the printing paper cannot be fed or just entered the printer. Its inspection procedure is: Check the feed sensor is normal, if not normal, you can clean the photoelectric sensor; Check whether the electromagnetic clutch of paper rubbing wheel is moving or not, and then measure whether the electromagnetic clutch coil voltage is normal or not, if it is, replace the clutch, if not, check the clutch drive circuit; Check whether the paper wheel is stuck with paper powder, waste powder, or aging. If you can clean the paper wheel with alcohol, or use fine sand paper to sand and polish it along the paper wheel, if not, replace the paper wheel; Check whether the supporting cardboard action, if not, then fix the cardboard cam. Through the above inspection, generally speaking, the paper jam can be eliminated. (2) the printing paper is jammed in the channel: Whether the printing paper is deformed in the channel; if it is, change the printing paper; Check whether the channel paper sensor is normal, if not, then clean the photoelectric sensor induction window; Check whether the paper feeding wheel is skid or not, if it is, the method of inspection and repair is the same as rubbing the paper wheel. (3) the printer is jammed in the fixing assembly, which is the place where the laser printer often jams: Check that the photoelectric sensor lever is normally reset, if not, fix the reset spring; Check whether the fusing board is melted and the toner is accumulated. If there is one, the accumulated waste powder is removed; Check whether the separation claw is damaged or contaminated with or without waste powder. If so, clean the separating claw or replace the separating claw; Check whether the photoelectric sensor is normal, if not normal, then clean the photoelectric sensor or reset spring. For several of these parts of the troubleshooting methods, in general, can do the f