详解绕线电阻.doc

品 名 繞 線 電 阻 器 Product Name Wire Wound Resistors PAGE 13-1 一般事項 General 適用範圍 Scope 本承認書適用於 [繞線電阻器]。 This specification is available for Wire Wound Resistors. 品質 Quality 本電阻器的製造係經高品質管理程序，並具有高信賴性的品質保證。 The resistor is manufactured by highly quality-controlled process and guaranteed high reliability. 標準試驗狀態 Standard measuring conditions 溫度20±2℃、濕度65±5%。 但在溫度5～35℃、濕度45～85%之情況下，仍可給予判定。 Temperature 20±2℃, Humidity 65±5%. Being no doubt about the judgment, measurements can be made within the following Temperature 5～35℃, Humidity 45～85%. 形名 (例) Type designation (example) 依使用種類、額定電力、形狀、電阻值容許差、公稱電阻值而區別，其構造如下： The type designation shall be in the following form and as specified. KNP 1/2W T-52 J 10R 品 名 繞 線 電 阻 器 Product Name Wire Wound Resistors PAGE 13-2 額定電力 Rated power 額定電力係適應在周圍溫度70℃可以連續負載的最大電力，如表-1；但周圍溫度如超過70℃時之額定電力則依圖一的電力輕減曲線實施。 Rated power is maximum power which can be continuously loaded at specified ambient temperature 70℃, however when the ambient temperature exceeds 70℃, rated power should be determined from the derating curve of Fig.1. 品 名 繞 線 電 阻 器 Product Name Wire Wound Resistors PAGE 13-3 額定電壓 Rated voltage 額定電壓係指對應於額定電力的直流或交流（商用頻率之有效值）的電壓，由下式求得。 The rated voltage shall be the D.C. or A.C. (R.M.S. at power frequency) voltage which corresponds the rated power and the value of which is calculated from the formula below. 公稱電阻值 Nominal resistance values 公稱電阻值係按表-2之數乘以10n(n為整數)之數值，其單位為歐姆(Ω)。 公稱電阻值之範圍則按表-1所示。 The nominal resistance values shall be the numerical values given in Table-2 multiplied by 10 n (n is an integer) in the unit of ohm(Ω). The minimum resistance and maximum resistance shall be as given in Table-1. 品 名 繞 線 電 阻 器 Product Name Wire Wound Resistors PAGE 13-4 1.8構造 Construction .1外形寸法 External dimensions 參照本仕樣書的「4. 外形寸法」。 The dimensions shall be satisfied with 「4. External dimensions」. 構造圖 Structure diagra