锅炉房（Boiler Room）.docVIP

锅炉房（Boiler Room） The third chapter, burning facilities Section 1 facilities for coal burning Article 3.1.1 coal-fired boilers should be used near the coal species. Article 3.1.2 the combustion equipment of a boiler shall be adapted to the type of coal used and shall meet the following requirements: One, can better adapt to changes in load. Two, better energy conservation; Three, conducive to environmental protection. Article 3.1.3 a chain grate shall be adopted when choosing a combustion equipment with a layer (including a coal feeder or chain type). Article 3.1.4 a coal grate with a high coking capacity and broken coke shall not be used in its combustion equipment. Article 3.1.5 coal mill type selection shall be based on the characteristics of coal-fired. The direct blowing pulverizing system should be adopted when choosing fan mill or hammer shaft coal mill. Each boiler should be equipped with 1 spare units. When the ball mill is used, the bunker type pulverizing system should be adopted. Each boiler should be equipped with 1 units of coal pulverizer, and its calculation output shall be less than 115% of the total amount of coal consumed by the rated evaporation capacity of the boiler. Article 3.1.6 the storage capacity of pulverized coal bin shall meet the boiler rated evaporation capacity of 3 ~ 5h coal consumption. Article 3.1.7 the design of the original coal bunker, pulverized coal bunker and coal caving pipe of the pulverizing system shall comply with the following requirements: The inner wall of a coal bin and coal should be smooth wear, wall angle of not less than 60 degrees angle for adjacent wall arc: The lower part of the two, the export of raw coal bunker, should set the circular hyperbola small metal coal hopper; Three, the coal tube will be round, and properly increase its tilt angle; Four, coal bunker should be sealed and measuring powder facilities, and must prevent heating and moisture. The metal coal bin should be kept warm. Article 3.1.8 of the