6tn-s tn-c-s tn-c tt it等接地系统的区别（）.docVIP

6tn-s tn-c-s tn-c tt it等接地系统的区别（） TN-S, TN-C-S, TN-C, TT, IT and other ground system differences Analysis of the grounding mode of low voltage power supply system I. power supply system for engineering construction The basic power supply system of power supply for construction is three-phase (), three wire and (380/220V) three-phase four wire system, but these terms are not very strict. The International Electrotechnical Commission (IEC) has made uniform regulations, which are called TT system, TN system and IT system. Among them, TN system is divided into TN-C, TN-S and TN-C-S systems. Here is a brief analysis of the various power supply systems mentioned above. (1) the basic mode of engineering power supply; According to the various protection modes and terms defined by IEC, the low-voltage distribution system is divided into three kinds according to the grounding mode, namely, TT, TN and IT systems, as follows. (1) TT mode power supply system TT means the direct protection system of the metal casing of the electrical equipment, called the protective earthing system, also known as the TT system. The first symbol T denotes the direct connection of the neutral point of the power system; the second symbol T represents the load equipment; the metal case and the normal uncharged metal part are directly connected to the earth and are independent of how the system is grounded. 1) when the metal casing of the electric equipment is charged (the phase line meets the shell or the equipment is damaged and the electricity is out of circulation), because of the earthing protection, the risk of electric shock can be greatly reduced. However, the low-voltage circuit breaker (automatic switch) does not necessarily trip, resulting in leakage of equipment of the earths surface voltage is higher than the safety voltage, belonging to the dangerous voltage. 2) when the leakage current is relatively small, even if the fuse does not necessarily fuse, so the leakage protector is needed fo