cisco交换机设置点滴（Set the Cisco switch bit by bit）.docVIP

cisco交换机设置点滴（Set the Cisco switch bit by bit） Switch virtual network (Virtual, LANs) settings: Catalyst 5000 to achieve VLAN partition and external VLAN routing settings Assign the VTP domain (a, VTP, Domain) Add Cat5000 to domain Specify the relay port (a Trunk) Dynamic ISL Assign VLAN to port Setting VLAN 20 Configuring Router ------------------------------------------------------------------- Note: there are three VLAN, routed between VLAN through Router ----------------------------------------------------------------- a VTP Domain What is VTP? VTP VLAN Trunk is short for Protocol, which provides each device (router or LAN-switch) at the relay port (trunk ports) broadcast. These broadcasts are sent to a multicast address, and all the adjacent equipment to receive these broadcasts. List management domain sending device, its configuration revision number, known as VLAN. To determine the parameters and the known VLAN. By listening to these broadcasts, can learn to configure the sending device on the new VLAN. using this method in all devices on the same management domain, the new VLAN only need in the management area on a device built and configured. Information will automatically be other devices on the same management domain the learned. a VTP Domain First, VTP domains (a, VTP, domain, name) are assigned, and switches in the same management domain can learn VTP information from each other through the VTP protocol Cat5001 (enable) sho VTP domain Domain, Name, Domain, Index, VTP, Version, Local, Mode ------------------------------------------------------------------ 11 server Advt, Interval, Vlan-count, Max-vlan-storage, Config, Revision, SNMP, Traps -----------------------------------------------------------------disabled Last Updater - 0.0.0.0 Cat5001 (enable) Cat5001 (enable), set, VTP, domain, Cisco VTP domain Cisco modified Cat5001 (enable) sho VTP domain Domain, Name, Domain, Index, VTP, Version, Local, Mode ------------------------------------------