初三物理中考总复习电学部分易错题分析（Analysis of three physical review electrical part of senior high school entrance examination fallible questions）.docVIP

初三物理中考总复习电学部分易错题分析（Analysis of three physical review electrical part of senior high school entrance examination fallible questions） This article is contributed by liuyang508116 DOC documents may experience poor browsing on the WAP side. It is recommended that you first select TXT, or download the source file to the local view. Analysis of three physical review electrical part of senior high school entrance examination fallible questions 1. cases of a positively charged electroscope, its foil open a certain angle with another conductor insulation handle electricity) near the metal ball is found, the foil electroscope angle decreases, live on the conductor, which of the following statements is correct (A. only negatively charged B. could only take positive B. may be negatively charged or uncharged D. may be positively charged or not charged the electroscope foil angle reduction foil novel Ming positive charge is reduced, and the metal ball on a positive charge increase, this is obviously the conductor unlike charges attract results. This shows that the conductor is not possible to positively charged conductor. Negative charge is possible. But if the conductor is not charged, close to the positively charged metal ball, because of electrostatic induction, the proximal end of the conductor will appear dissimilar charge - negative charge, the distal will appear the same charge -- a positive charge, the induction He will also have the positive charge on the metal ball attraction, the positive charge on the foil is reduced, so the complete answer is: negatively charged or uncharged are possible. The correct answer is C. 2. a bulb nameplate marked PZ220 - 100, at room temperature by voltammetry measured the filament resistance it is R1, then the normal work voltammetry measured the filament resistance of R2=48.4 in Europe, R2 found that more than 10 times higher than R1 (A.), which is due to the previous measured resistance must be wrong B. after a measured value is wrong fo