装修的施工工艺（Decoration construction process）.docVIP

装修的施工工艺（Decoration construction process） Renovation of the construction process, electrical installation I. basic provisions 1., in strict accordance with electrical design drawings. (in case of construction and actual problems, the designer and the project manager will give the solution after construction on site) and after the completion of the project, the owner shall provide the owner with the complete drawings of the electrical works. 2. construction personnel should hold electrician certificate before they can enter the operation, and the construction electrician shall establish temporary construction electricity system at the beginning of the construction site. 3. construction may not damage anti-theft and intelligent management system device. Not allowed to shift in principle. 4., comply with the relevant provisions of property management, civilized construction, safety first. Two. Material acceptance. The 1. approach Dianliao, appliances must conform to the provisions of the contract, the main electrical appliances must have a product certificate. 2., a material for electrical access, must apply for acceptance, signing, for unqualified products, electricians have the right to propose replacement. Electrical material certificate, warranty, manual completion should be complete to the owners. Three. Shunt distribution 1., according to the design requirements, each households indoor electricity should be strictly shunt, the original distribution box depending on the number of design loop enough to decide whether to change or not. The 2. approach according to the diagram and the owners intend to establish the switch socket location, wiring to co-ordinate arrangements, wall pipe laying pipeline to slot into the wall must have cement mortar protective layer is greater than 1cm. 3. wire pipe and gas pipe, pipe spacing should be greater than 5cm, the parallel is not less than 10cm, the joint line between the tubes to use special connections, and special glue, fixed