abs表面喷漆（ABS surface spray paint）.docVIP

abs表面喷漆（ABS surface spray paint） Bookmark to skip to bottom ABS surface spray paint This article is contributed by hdy369 DOC documents may experience poor browsing on the WAP side. It is recommended that you first select TXT, or download the source file to the local view. ABS surface paint of motorcycle (Scooter) above appearance decoration 80% is made of ABS plastic products, so the coating quality directly affect the market competitiveness of motorcycle. In this paper, the pretreatment and coating process of ABS plastic products are introduced, and some special requirements for pretreatment and coating of ABS plastics are analyzed and discussed. The surface characteristics of ABS 1.9.2 (acrylonitrile, butadiene and styrene copolymer three yuan) is a thermoplastic resin plastic, has high mechanical strength and good processing performance, but its low hardness, weatherability, poor solvent resistance, can be improved by two times the processing of plastic surfaces. Coating is one of the important methods of plastic surface two times processing. ABS plastic coating adhesion effect is not good, often lose light on the problem, the main reason is that the surface tension (less than 100mN/cm), solubility parameter differences between the resin and the solvent solubility parameters and coating in large internal stress generated in the molding is easy to produce cracks or reduce gloss coating film defects such as surface the electrostatic adsorption and dust, affects the coating effect. 1.9.3 surface pretreatment oil plastic surface will greatly reduce the adhesion of coatings containing remover oil (stearic acid salt, wax and polyvinyl alcohol), additives (plasticizer, lubricant, antistatic agent, anti-aging agent, flame retardant), other (lubricating oil, dust, etc.). The processing method of (1) manual smear method this method is usually applied to high labor intensity, low yield condition. Hand wipe the many ills, due to artificial reasons, leading to unstable qual