cam350学习（CAM350 learning）.doc

cam350学习（CAM350 learning） CAM350 V8.0 above how to customize fast Jian? Answer: in the blank space of the menu bar, right-click and click Customize to enter. Select the keyboard option, select the menu in the command in Category, select the command in Commands, enter the key defined in the Press New Shortcut, and click Assign to complete. Any key can be set. How to fill a polygon in CAM350 Answer: Add - Polygon, Select Border and Fill to select Border two, PolygonClearance will change the spacing to zero. The filled polygon must be a closed graph. Click one side of the polygon, then right-click, and then click on the other side. Until all the edges are lit, double-click the right button to fill it up. In addition, can also use the Edit Line Change - Join - Segments command all edges of polygon into a whole after filling. How to align the position after CAM350v8.0 is transferred to Gerber and Dill data Answer: EDIT - LAYERS - ALIGN command. Select the order in that a real PAD layer of the single point on the left, and then right click to confirm the point, then you want to move the layer in corresponding point click the left, at which point it will become white, double-click the right button to align. When you delete a lot of things, you accidentally choose not to delete, and then you need to cancel the re selection Answer: press CTRL+ mouse click, need not delete the part, can resume. How to add tears in CAM350? Answer: utilitiesteardrop, the line from the PAD will need to be long enough to be added from the PAD center. CAM350 midline to PAD, can only turn round, rectangle, oval, and other irregular shapes how to turn? Answer: Utilities To Flash - Interactive - Draws How to select lines or pads in CAM350, and automatically capture their endpoints and centers, just as in V2001, after you press the S button, you can select the line and automatically display the current D code Answer: press the Z key, and its role is the same as the V2001 S. Sometimes press the