tcl总线进入方法（TCL bus access method）.docVIP

tcl总线进入方法（TCL bus access method） Indicates access to maintenance mode. 2. exit of maintenance mode After the adjustment is completed, press the TV button on the remote control to exit the maintenance mode. 3. adjustment method (1) adjust the selection of the project 2 TCL bus access method Press the number 0~9 button and the letter key on the remote control to enter the selection of the adjustment item, and the name of the adjustment item will change accordingly. (2) adjustment of data selection; According to the VOL or VOL button, the data can be adjusted to increase or decrease, adjust the data will change. Two, applicable models: TCL-2501 Enter the factory model. After the host of the voice hold, wait until after 0, according to the three (note that the time required to complete in 1.5 seconds) remote 0 key, the screen factory mode menu, then menu option and options, increasing change and cut change button in the -2 menu in the factory model choice . After that, the factory debug the remote control can be used properly, but remember to turn off the factory mode, and then use the remote control menu key to quit the factory settings menu. Three, applicable models: TCL-2101, 2501, -2501A, 2501C, 2501F, 2510C, 2511C, 2503C, 2536F, 2568C, 2901, 2901A, 2901C,, 2901F, 2909A, 2966G, 2969B, 2976A Entry of maintenance status (1) enter: press and hold the main volume, reduce the key, do not put, to 0 when, press the remote control 0 button three times (note that the time should be completed within 1.5 seconds). (2) operation; use the top and bottom options of the remote control and the add and change button to complete the factory settings, and change all the parameters. The exit method exits the factory setup menu with the remote control platform key. Note: when you exit the factory setup menu, make sure that the factory mode is set to off and that the setting is only remembered when you exit the factory settings menu. Four, applicable models: TCL_2129E, 2133 2175E Mainten