机构设计规范（Code for design of mechanisms）.docVIP

机构设计规范（Code for design of mechanisms） This article by my struggle for their contribution DOC documents may experience poor browsing on the WAP side. It is recommended that you first select TXT, or download the source file to the local view. Institutional work specification Front word The purpose of this book is to make the standard mechanism design staff doing product design, sample making, sample inspection, die when there is a basis to avoid inadvertent mold test found only need to do the design change, even to die to reopen the risk of scrap. Mechanism design personnel must be stated in the form of project specification according to the customer to confirm in the map before opening or before each inspection in the design. And, in each column position before and after submit audit. The design and inspection of the sample after the design must be carried out without any subsequent modifications. After opening the mold each stage work according to the regulation one by one, must not have the omission. If any oversight of the regulatory items is omitted by the head of the organization at any time, the new head of personnel must be trained and instructed in accordance with this book. One order Part design second Page I. plastic parts design 3~5 two. Hardware design 6. Three. Design of rubber parts .. 7. Four. Design of wood parts 8. Five. Electronic component design 9. Sample making ..10 sample inspection ..11 mold opening, mold testing and review .12~13 Two Part design I. plastic parts design: plastic parts design: OK N/A 1. all the appearance of reach of the edge or corner, there should be at least more than R1. The 2. draft at least 1 degrees above is preferred. 3. of all the screws into the length of the screw column must have at least 4. more than 4mm. If there is more than the average thickness of flesh? 5. of the thickness of rib is in the flesh of 1/2 below the 6. average? Whether moving parts are tensile or 5kg 10kg pressure? 7. movable parts between adja