文本文（Wenbenwen）.docVIP

文本文（Wenbenwen） I. construction preparation 1, the construction of grass-roots base material surface should be smooth, clean, and has good strength, the new wall should work for a month, before construction, renovation of the old wall, to remove loose leveling base, surface spalling and dust, grease and other impurities before construction. 2, spraying the base surface should be dry, water content shall not be greater than 10%. 3, the temperature requirements of temperature above +5 degrees, below 50 degrees, less than +5 can not be built. 4, rain, snow, ice can not be built. Two, construction technology and process points 1, process flow Surface treatment, spraying sealing primer, coating, spraying truestonepaint main auxiliary treatment, coating varnish (overlay) 2, process points (1) metope treatment; 1), the requirements of surface roughness, metope dry (cement mortar surface should be maintained for more than 15 days), no dust, asphalt and other stains, water content and PH 10, 10%. The plane error shall not exceed 3 millimeters. 2) primary treatment; with the shovel eradication wall floating layer and old cement dust floating layer, ensure that the basement wall firmly, remove impurities, repair of porous, rough surface, and the grinding wheel, grinding. 3) local ash polishing, wall Yin and yang angle correction: A, yang angle gap, the local repair construction of cement and 801 binder mix fine nap. B and Yang protruding parts use grinding wheel grinding to achieve the overall effect. C, such as hanging gray shade horn using blade cleaning, achieve the smooth wall. (2) spray sealing primer: evenly coat a layer of primer on the treated base surface, and then apply the bottom sealing treatment. The drying time of the primer is about 60 minutes or more. A. neutralization treatment: with special neutralizing alkaline wall and in the processing, to ensure that after the construction of the wall is not extensive, the amount of about 0.1-0.2kg/m2. B. primer Construc