浙大《电力电子技术》在线作业(Zhejiang University power electronic technology online homework).docVIP

  • 3
  • 0
  • 约1.06万字
  • 约 19页
  • 2017-10-07 发布于河南
  • 举报

浙大《电力电子技术》在线作业(Zhejiang University power electronic technology online homework).doc

浙大《电力电子技术》在线作业(Zhejiang University power electronic technology online homework)

浙大《电力电子技术》在线作业(Zhejiang University power electronic technology online homework) 14 spring, 13 autumn, 13 spring, Zhejiang University power electronic technology online homework answer Total score: 100 test time: - Radio examination Judgment question Radio examination questions (20 questions, 40 points) 1. according to the output voltage, half cycle pulse number fixed or change, PWM does not include () A. synchronous modulation B. Asynchronous Modulation C. piecewise synchronous modulation D. segment Asynchronous Modulation Full marks: 2 The power factor of the thyristor converter is independent of (2.). A. voltage and current lag angle B. back EMF C. AC side inductance D. current waveform Full marks: 2 3., the voltage type inverter is incorrect A. approximate sine wave, have larger harmonic component The B. does not require a freewheeling diode C. applies to multi machine power supply irreversible traction occasions D. overcurrent and short-circuit protection Full marks: 2 4. the following on the Boost-Buck transform circuit and K conversion circuit C case is not correct (is) The input current and the output load current of the A. Boost -Buck converter are continuous and the ripple is small, which is beneficial to the filter B. C K converter is connected with transmission power capacitor Boost -Buck converter by transmission power inductor, so pulse capacitor C1 C connected K converter in large current, large capacity requirements To the current flowing through the inductor L1 and L2 C. C connected K converter VT turn-on, the peak current of the power switch so big D. two can implement the DC-DC transform Full marks: 2 5. the following statement about the thyristor transient voltage sharing in series is incorrect A. should take full account of junction capacitance, triggering characteristics, turn-on and turn off characteristics B. plus RC RC implementation The C. capacitor can prevent the di/dt from getting too large D. considers voltage distribution unevenly and u

文档评论(0)

1亿VIP精品文档

相关文档