电铬铁的使用（Use of ferrochrome）.docVIP

电铬铁的使用（Use of ferrochrome） Electric iron is the most commonly used welding tool. We use 20W internal electric soldering iron. Before the new iron is used, apply the fine sand paper to polish the iron head and heat the electricity. After dipping the rosin, contact the solder wire with the head edge of the soldering iron to evenly coat the tin on the head of the soldering iron. In this way, it is easy to weld and prevent the surface of the iron head from oxidation. If the old iron head is blackened by severe oxidation, the steel can be depressed and removed to the surface oxide, so that it can be plated again after being exposed to the metallic luster. Electric iron to use 220V AC power, use should pay special attention to safety. The following should be conscientiously done: Plug the electric iron preferably with a three pole plug. Make sure the casing is properly earthed. Before use, should carefully check the power plug, power cord damage. And check if the iron head is loose. The electric iron can not be struck with force. To prevent falling. When the soldering iron is too long, wipe it with cloth. Dont throw it away in case it burns others. In the process of welding, soldering iron can not be everywhere. When soldering, it should be placed on the iron rack. Note that the power cord can not be attached to the iron head, in order to prevent burning insulation and accidents. After the use, should promptly cut off the power supply, unplug the power plug. After cooling, then return the electric iron to the tool box. 2 solder and soldering flux Solder and soldering fluxes are needed for soldering. (1) soldering: welding electronic components, usually using rosin cored solder wire. The solder wire has lower melting point and contains rosin flux and is extremely convenient to use. (2) flux: the commonly used flux is rosin or pine perfume (rosin soluble in alcohol). The use of flux can help remove the metal surface oxides, welding, and can protect the iron head. Solder pas