空调的拆卸（Disassembly of air conditioner）.docVIP

空调的拆卸（Disassembly of air conditioner） First, the air conditioner outdoor liquid tube (that small copper tube) of the copper valve switch cover to unscrew, with six angle wrench clockwise valve closed. Let the air conditioning running about 5 minutes (to set a low temperature refrigeration compressor, ensure that the aim is to turn up, the refrigerant indoor machine and two tube all recovered to the outdoor machine), two brass valve temperature beside the outdoor machine to touch, the size of copper without cold feeling (that has been refrigerant recovered), using the same method to the trachea (Rough brass) valve shut after shutdown (unplug the power plug), then remove electrical connection line under outdoor machine. Open two brass fittings, tube straight tube, one indoor hanging lower along the wall again pull up on the hole along the pipe pulling out, another person will be outside the hole in the wall to send along the tube (Caution!, as long as can be directly removed from the cabinet). Remove the indoor machine, the tube is pulled straight and then turn to bend (be careful handling by bending brass). Pry down the indoor machine hanging board, remove the outdoor machine foot screws (such as high altitude should pay attention to safety, two valve door should be bandaged, in case of impurities and moisture into), and finally remove the outdoor machine mounting frame. The whole demolition work has been completed. Air conditioning service procedure two: accurate fluorine adding method Adding fluorine is a basic skill of air conditioning maintenance, and it is also a highly technical work. This article introduces some experience that the author tries to find out in the practice of maintenance, and discusses with readers. First, the premise of accurate fluoride 1. maintenance of air-conditioning must comply with its use conditions and installation standards. 2. maintenance of air conditioning control systems and components must be normal; piping system must have been