ones刻录详解（Ones刻录详解）.docVIP

ones刻录详解（Ones刻录详解） [ONES burning method detailed] [a] using ONES software to burn CD discs, there are four options in the burning method. Track At once---Mode 1--open Track At once---Mode 1--Closed Track At once---Mode 2 --open Track At once---Mode 2 --Closed Session At once---Mode 1--open Session At once---Mode 1--Closed Session At once---Mode 2 --open Session At once---Mode 2 --Closed Track At Once - track recording (TAO mode) Session At Once----------- section burn (ie SAO mode) Track burn (Track At Once, ie TAO mode): The rail unit - burning. It supports data written into several tracks several times to a single section, and is mainly used for making music discs or hybrid and special types of compact discs. Section burn (Session At Once, that is, SAO mode): This is only a section of the write mode to burn a rather than the entire disc, disc space remaining next time you can continue to use; making in section CD-ROM. The advantages are suitable for the production of CD collection types. But each time the new section is burned, about 13MB of the compact disk space is used to store the structure of the section and the connection information of the previous section, and to prepare for the next section. Therefore, too many sections will waste more disk space, it is not worthwhile. Mode 1: - joined ECC in CD-ROM (Error Checking and Correction, error checking and correction) check, each magnet can store 2048 Byte data, conventional data for storage. Mode 2: Is the removal of the ECC checksum, adding file storage space, each magnet can store 2336 Byte, suitable for storing graphics and music data. ---------Open ------------------------ (open end moment not sealed) ---------Close------------------------ pass (seal) ---------Mode1---------------------- (data structure with ECC error correcting code, which is used in general CDROM) ---------Mode2/XA------------------ (without ECC data structure, larger capacity, but the error correction performance is poor, the use of the