pe80 压力等级（PE80 pressure rating）.docVIP

pe80 压力等级（PE80 pressure rating） PE material is polyethylene, is the largest amount of plastic materials, it is made of polyethylene polymer material. Basically divided into two categories: low-density polyethylene LDPE (low strength); HDPE HDPE. PE materials are divided into five grades according to international standards: PE32, PE40, PE63, PE80 and PE100. PE uses a wide range, and is divided into high-density, low density and linear PE, most of the daily application is made of a variety of plastic film and plastic sheeting. A medium density polyethylene pipe and PE pipe with high density polyethylene pipe. Divided into SDR11 and SDR17.6 series according to the wall thickness. The former is suitable for transporting gaseous artificial gas, natural gas and liquefied petroleum gas. The latter is mainly used to transport natural gas. Compared with the steel pipe, the construction process is simple, flexible, and more importantly, no corrosion treatment, it will save a great deal of work. Shortcomings as equipment pipe, heating special attention to safety distance in construction, and can not be exposed in the air under the sun, and sensitive to chemicals, to prevent leakage of sewage pipe damage. For the production of PE pipe for water supply pipeline of HDPE high density polyethylene, the grade is PE80, PE100 two (Minimum Required Strength based on the minimum requirements for the strength of the acronym MRS). The MRS of PE80 reaches 8MPa; the PE100 of MRS reaches 10MPa. MRS refers to the tensile strength of the tube under cyclic stress (calculated according to the international standard test). Brief introduction of cross linked polyethylene pipe (PEX) pipe High density polyethylene (HDPE and MDPE), its molecular linear knot, the biggest drawback is the heat resistance and creep resistance, so the ordinary high density polyethylene pipe is not suitable for conveying medium temperature greater than 45 DEG C. Cross is an important method for the modification of polyeth