普通车床细长轴零件夹具设计方法（Fixture design method for slender shaft parts of general lathe）.docVIP

普通车床细长轴零件夹具设计方法（Fixture design method for slender shaft parts of general lathe） Method of fine long axis of car (Part 2) Release: 2011-8-23 | - Author: | source: mahuaxiao | view: 647 | user attention: 1. under what conditions do you use the center frame and the heel rest? Answer: the turning axis, the workpiece fixture if it is stretched out over a length of 15 times the diameter of the smooth shaft (such as lathe bar), with chuck support tip, with knife clamping, or before and after the tip, with knife clamping support. Bench shafts (such as lathes, spindles, etc.) shall be fitted with chuck