汽车（automobile）.docVIP

汽车（automobile） The crankshaft has the front end of the crankshaft, the crank and the rear end of the crankshaft Inline type: crank number equal to cylinder number; type V: crank number equal to half of the cylinder number; The crankshaft is divided into fully supported crankshaft (spindle neck equal to cylinder number plus one) and non fully supported crankshaft Straight row full support crankshaft spindle neck equal to cylinder number plus 1; Fill in the blanks (12 points) 1. engines are usually composed of crank connecting rod mechanism, gas distribution mechanism, fuel supply system, lubrication system, cooling system, ignition system and starting system. 2., the two stroke engine, each completed a cycle of work, the crankshaft rotation for a week, the piston in the cylinder from the lower dead point up to the point of operation, the completion of exhaust and compression The stroke is completed from the upper dead point to the running point and the intake stroke. The 3. piston connecting rod group is composed of piston, piston pin, connecting rod, piston ring and so on. The spindle diameter of the fully supported crankshaft of the 4. V8 engine is 5. (8/2) +1 5. the transmission mode from crankshaft to camshaft is gear drive, chain drive, toothed belt drive and so on three. 6. the performance indexes of gasoline mainly include antiknock, evaporation and corrosiveness. 7. electronic control system of gasoline engine consists of three parts: electronic control unit, sensor and executor. 8. domestic A pump is composed of pump oil mechanism, fuel supply regulating mechanism, drive mechanism and pump body And so on four parts constitute 9. water-cooled engine cooling intensity adjustment device, mainly blinds, thermostat, radiator and so on. 10. in the engine lubrication system, the camshaft journal is lubricated by pressure. 11. the battery ignition system uses the ignition coil and the breaker to change the low voltage electricity into the high voltage electricity. T