监控摄像机常见故障排除（Surveillance camera common troubleshooting）.docVIP

监控摄像机常见故障排除（Surveillance camera common troubleshooting） Surveillance camera common troubleshooting Cameras and other electronic products often exist in various unforeseen problems, found many problems in our customer service service, because some of the on-site construction personnel on camera performance is not very understanding, which can solve the matter in the local, but back to the company, which not only waste your money, and delay time process, hereby lists some common problems, for reference only 1, infrared hemisphere machine at night, the image of poor illumination, white or bright white diaphragm phenomenon This phenomenon is caused by improper assembly of the machine assembly, photosensitive device (photosensitive resistance) from the hemisphere too far distance will lead to start the lamp by the incomplete machine at night illumination difference image; white or bright white halo phenomenon mainly due to infrared light emitting tube infrared light through the refraction lens to cover the ball due to solve this problem is to avoid the infrared light refraction to the lens surface, usually used for isolation sponge ring lens and infrared light, in the assembly will cover the ball close to the sponge ring 2, night vision infrared waterproof machine, the normal image during the day, whitening at night This phenomenon is generally due to the use of the environment are a reflection of machine or in a small space, due to light reflection, to solve this phenomenon should first determine whether there is a reflection of the environment, as far as possible to improve the use of the environment, then check the machines effective infrared distance and the distance is corresponding; if a long distance infrared machine in a very small space to use for infrared light is too strong to cause the machine white image. 3, no image First check the external power supply output voltage polarity is correct, whether meet the requirements (power error: DC12V + 10%, AC24V + 5%),