双洞单向公路隧道横通道定位及风机选型-cameo-计算机辅助多物理.pdf

第31 卷第2 期 建 筑 热 能通 风 空 调 Vol.31 No.2 2012 年4 月 Building Energy Environment Apr. 2012.99~102 文章编号：1003-0344（2012）02-99-4 双洞单向公路隧道横通道定位及风机选型 李含 孙三祥 张京龙 兰州交通大学环境与市政工程学院 运用双向换气设计算法，确定2000m 双洞单向公路隧道车行横通道最佳位置。单横洞距下坡隧道入口为 摘 要： 650m，相邻两横通道相距300m。基于流场分析原理，运用CFD ansys 软件三维数值模拟横通道及其附近区域的速 度场，在合理定位横通道的前提下设置风机调压，选定最佳风机类型和数量，保证通风负荷较小的下坡隧道内的 新风量通过横通道送至上坡隧道内。 关键词：纵向通风横通道数值模拟速度场风机选型 The Selection of the Fan in the Double Hole One-way Highway Tunnel 库 Channels under Best Positioning LI 例 Han, SUN San-xiang, ZHANG Jing-long Academy of Environmental and Municipal Engineering, Lanzhou Jiaotong University 案 Abst ract : Determined the best position of cross-channel in double holes one-way highway tunnel by using air E interchange. The single channel from the downhill tunnel entrance for 650 m, the best spacing between two horizontal A channels is 300 m. Based on the flow field analysis principle of operation ventilation system, and used CFD ansys C software to 3-d numerical simulate velocity field in the channel and the vicinity of it, set the fan under the premise of orientation the channel in reasonable for adjusting pressure, selected the best surge fan type and quantity, to ensure that 模 the fresh air in the tunnel which have smaller ventilation load delivered to the tunnel which have larger ventilation load through cross-channel. Keywords: longitudinal ventilation, channel, numerical simulation, velocity field, fan selection 楷