R1909-TheQuestforRFPowerAmplifierEfficiencyR1909-高.pptVIP

April 17, 2003 ? Freescale Semiconductor, Inc. 2004 Name of your presentation here ? Freescale Semiconductor, Inc. 2004 Presented by: Antoine RABANY 安邦福 Agenda 议程 Introduction 简介 Doherty Doherty 技术 Class F F类放大器 Drain Modulation 漏极调制 Conclusion 结论 Doherty PADoherty 功率放大器 Class F F类放大器 Typical “ideal” PA can achieve PAE ~ 50% at P1dB in Class A mode A类放大器方案在P1dB输出时，PAE可达到大约50%。 Goal of Class F is to ▲PAE while ▼Gain F类放大器的目的是增加PAE 同时减少增益 This can be accomplished by following four goals 这可以通过以下几个方法实现: Adds odd harmonics to shape the voltage waveform into a square wave Adds even harmonics to shape the current waveform into a half-rectified sine-wave. Consequently, VDS (t) and IDS (t) at f0 are shifted 180° from each other. This results in ▼ PDISS ? Increasing PAE during, for a given PIN. Class F is interesting to improve Efficiency closed to the compression Lower interest in back-off Which impact on linearity? Class F Harmonic Matching is more complex than conventional matching F类放大器谐波匹配比起通用放大器更加复杂 How to embed it in the package? 怎样把这个方案放入封装里？ No possibility to match for Class F a device designed for Class AB 无法用AB类放大器设计Class F Bandwidth evaluation 带宽问题 Class F needs high Ft Class F需要较高的Ft Drain Modulation漏极调制:-Envelope Tracking包络跟踪-Envelope Elimination Restoration 包络抵消和恢复 Basically, it consists in modulating the power capability of the transistor to adapt to the actual transmitted power, on a real time basis. The power modulation is achieved through modulating the Drain voltage: 通过调制漏极电压来进行功率调制 Pout = A x 20x log (Vds) Envelope tracking包络跟踪 WCDMA simulations results: modulated DC Drain Voltage Envelope tracking包络跟踪 Summary总结 LINC- Chireix High Efficiency PA:summary高效率放大器：总结 In ClosingReduction of heat and increased reliability are driving high efficiency techniques for RF Power Amplifiers最后，为了追求更高的可靠性和减少热耗，人们不断发展高效率放大器技术 Many techniques exist 现在有多种技术 Combining these techniques with Linearization is a necessity它们必须与线性化技术相结合 Questions?