真空吸尘器耐压测试规范.docVIP

真空吸尘器耐压测试 修订 日期 修订 单号 修订内容摘要 页次 版次 修订 审核 批准 2011/03/30 / 系统文件新制定 2 A/0 / / / 批准： 审核： 编制： 真空吸尘器耐压测试 1.0 Purpose / 目的 To evaluate the performance of dielectric voltage-withstand of the sample 评估样机绝缘材料的绝缘耐压性能. 2.0 Definition/概念: None 无. 3.0 Reference Documents/参考文献: U.L.1017 CAN/CSA-C22.2 NO.243-01, dated 12-7-2001,CL 5.11 4.0 Equipment/设备: Withstanding voltage tester(耐压测试仪). 5.0 General Instructions/说明: 5.1 Tests may be conducted at any ambient temperature within a range of 10-40℃ (50-100℉). 测试可在10~40℃(50~100℉)之内的环境温度下进行. 5.2 Unless otherwise noted, all tests are to be conducted with appliance connected to a 120VAC, 60Hz power source. 除非另外标注, 否则所有样板都将连接在120V/60Hz电源下进行测试. 5.3 All equipment used must be calibrated on an annual basis. Calibration stickers with last calibration and calibration due date must be affixed to each instrument. 使用的所有设备都必须以一年为周期进行调校.载有最后调校日期和调校周期的调校粘纸必须粘固在每一个仪表上. 5.4 Apply a 60-hertz essentially sinusoidal potential between current-carrying parts and dead metal parts. 在带电零部件和不带电零部件之间施加60Hz测试电压. 5.5 Determine the test voltage(测试电压的判定): a) One thousand volts for a sample employing a motor rated 1/2 horsepower (373 watts output) or less; 马达功率标称小于373瓦的样机, 测试电压为1000V. b) One thousand volts plus twice the rated voltage for a sample employing a motor rated more than 1/2 horsepower, or except as noted in (c) a sample applied directly to persons or supported by the body of a person. 马达功率标称大于373瓦其直接与人体接触或由人体支撑的样机（此条排除以下c情况）, 测试电压为1000V加上二倍的额定电压240V, 即为1240V c) Twenty-five hundred volts for a wet pick-up sample that is supported by the body of a person but not solely hand held; 对于人体支撑而不是只用手持的吸湿式样机应为2500V. Test duration is 1 minute 测试时间为一分钟. 6.0 Procedure/步骤: 6.1 Obtain a representative sample of the appliance to be tested. 准备一个有代表性的样机用于测试. 6.2 Obt