Gsm呼叫流程(中文)-2017年10月.ppt

* Authentifiaction procedure (MM Procedure): To check if the identity of the mobile is acceptable or not. Provide parameters enabling MS to calculate the new ciphering key. This procedure is used at each call setup, suplementary service, location updating. Identification procedure (MM Procedure) : Procedure used by the network to request a Mobile station to provide his IMSI Ciphering Mode setting procedure (RR Procedure) :Used to set the ciphering mode. Indicate wether ciphering shall be used or not and if yes which algortihm to use TMSI Realloc Proc (MM Procedure) : Provide identity confidentiality to the MS. The TMSI has significance only within a location area. * * OACSU : Off Air Call Setup : allow the late assignment of the TCH (after the Alerting). This feature allows an increase of the efficiency of the TCH. Queuing : allows a TCH channel allocation to be queued for a time whilst no TCH free Directed Retry : allows the BSS to assign a TCH on another cell by internal handover * Phys Con Req : Allow the BSC to obtain information on the phsical context of a radio channel just prior to a channel change.Includes the BS Power, MS Power, TA Assignment Request : Detail of the resource that is required (channel rate, channel type,...). It also include the terrestrial circuit that shall be used between the BSC MSC. If the Assignment is not completed, the Assigenemtn failure is send on A interface with cause : RIMF : the BSS doesnt receive the Assigenemtn complete RIF : failure on the Radio or A-bis interface during activation of the channel No Radio Resource available Requested Terrestrial Resource unavailable Requested Terrestrial Resource alreqdy allocated Radio Interface Failure, Reversion to old channel Ciphering Algo not supported Assignment Command : send on SDCCH - to change the Channel configuration SABM, ESTIN, UA : see Radio Link Establishment C16 : incremented when a RTCH channel has been successfully selected for any other purpose than