结构参数对非对齐入口式T型微混合器内混合特性-北京工业大学学报.PDFVIP

第40卷 第2期 北 京 工 业 大 学 学 报 Vol.40 No.2 2014年 2月 JOURNAL OF BEIJING UNIVERSITY OFTECHNOLOGY Feb. 2014 结构参数对非对齐入口式T型微混合器内 混合特性的影响 李摇 健,夏国栋,李艺凡 (北京工业大学 环境与能源工程学院强化传热与过程节能教育部重点实验室,北京摇 100124) 摘摇 要:对非对齐入口式T型微混合器内流动与混合特性开展了三维数值模拟. 结果显示,非对齐式入口的布置 方式使流体流入通道时在重力方向上出现位移差,增大了流体的接触面积且沿通道轴向方向上出现明显的旋流状 运动,从而进一步强化混合. 同时,结合数值模拟和田口优化法对影响该微混合器混合性能的3个设计参数进行比 较和分析,并结合信噪比的变化确定了非对齐入口式T型微混合器的最佳结构设计方案. 这些参数对混合的影响 强度分别为:入口通道宽度w入口通道与主通道高度比h/ H入口通道入流角度琢. 关键词:非对齐入口式;混合特性;结构参数; 田口优化法 中图分类号:TQ027郾35;O351郾2 文献标志码:A 文章编号:0254-0037(2014)02-0296-06 Influence of Geometrical Configurations on Mixing Performance in T鄄shaped Micromixer With Non鄄aligned Inputs LI Jian,XIA Guo鄄dong,LI Yi鄄fan (Key Laboratory of Enhanced Heat Transfer and Energy Conservation,Ministry of Education,College of Environmental and Energy Engineering,Beijing University of Technology,Beijing 100124,China) Abstract:The flow and mixing performance of fluid in T鄄shaped micromixer with non鄄aligned inputs are investigated numerically by using a three鄄dimensional numerical simulation method. The analysis results show that the displacement differences appear in the direction of gravity due to the arrangement of non鄄 aligned inputs. Afterfluidflowingintothechannels,thefluidcontact areasincrease. Theapparent spiral flows are generated along the axial direction of the channel, thus further strengthening mixing performance. Meanwhile,this paper presents a numerical design methodology for different geometrical configurations,which systematically integrates computational fluid dynamics (CFD)with an optimization methodology based on the use of Taguchi method. The g