高炉熔渣直接纤维化制备矿渣棉实验研究.pdfVIP

高炉熔渣直接纤维化制备矿渣棉实验研究 ·1 · 高炉熔渣直接纤维化制备矿渣棉实验研究 龙 跃1,2 杜培培1,2 李智慧1,2,3 张良进1,2 张玉柱1,2 （1. 华北理工大学冶金与能源学院，河北唐山 063009 ； 2. 华北理工大学现代冶金技术教育部重点实验室，河北唐山 063009 ； 3.东北大学材料与冶金学院，辽宁沈阳 110004 ） 摘 要 通过利用喷吹法和四辊离心法制备矿渣棉，研究在不同制备方法条件下，矿渣棉其化学稳定性、表观特征、 含水率及渣球含量与酸度系数之间的关系。结果表明：在满足成纤要求的前提下，高炉渣酸度系数应控制在1.2~1.4； 利用喷吹工艺制备的矿渣棉直径较细，含水率较低，成纤率较低，渣球含量较高纤维质量较差；相对于喷吹工艺离 心法制备的矿渣棉直径相对较粗，含水率大，渣球含量较少，成纤率较高，纤维质量较好。 关键词 高炉渣，矿渣棉，喷吹，离心 Experimental Study of Blast Furnace Slag Slag Wool Preparation Directly Fibrosis Long Yue1,2, Du Peipei1,2, Li Zhihui1,2,3, Zhang Liangjin1,2, Zhang Yuzhu1,2 (1. School of Metallurgy and Energy, North China University of Science and Technology, Tangshan, 063009, China; 2. Modern Metallurgical Technique Key Laboratory of Ministry of Education,North China University of Science and Technology, Tangshan, 063009, China; 3. College of Material and Metallurgy, Northeastern University, Shenyang, 110004, China) Abstract The slag cotton was prepared by spray blowing and four centrifugal centrifugal preparation. Under different methods, the relationship between slag wool, chemical stability, surface characteristic, water content and slag content and the acidity coefficient is studied. The results showed that under the premise of meet the requirements of fiber forming, the acidity coefficient of blast furnace slag should be controlled at 1.2~1.4, the diameter of slag cotton of blowing process is smaller, the water content is low, but the content of slag ball is high, the diameter of slag cotton of centrifu