镁合金管材的热态内压成形起皱行为分析-中冶有色技术网.pdfVIP

第 20 卷第 3 期 中国有色金属学报 2010 年 3 月 Vol.20 No.3 The Chinese Journal of Nonferrous Metals Mar. 2010 文章编号：1004-0609(2010)03-0385-05 镁合金管材的热态内压成形起皱行为分析 汤泽军，苑世剑，刘 钢 (哈尔滨工业大学 材料科学与工程学院，哈尔滨 150001) 摘 要：利用数值模拟和塑性理论分析 AZ31B 镁合金管材的热态内压成形过程的变形机理，找出临界起皱应力、 应力状态及皱纹形状的变化规律。结果表明：随着温度升高，管材轴向抗起皱能力下降，其机理是材料的屈服强 度和弹性模量随温度升高而下降；皱峰和皱谷处应力轨迹均在环向应变伸长和轴向应变压缩的区域；随着补料量 的增大，皱峰处应力向壁厚减薄的方向发展，皱谷处应力向壁厚增加的方向发展；内压与材料屈服强度之比(相对 压力)决定初始屈服时皱峰和皱谷处壁厚的变化情况，即温度较高时，相对压力较大，初始屈服时皱峰和皱谷处应 力状态越易处于管壁呈减薄趋势的区域；当温度较低时，相对压力较小，初始屈服的皱峰和皱谷处的应力状态越 易处于管壁有增厚趋势的区域；随着温度升高，相同加载路径下皱纹的高度和波长增大，皱纹趋向于向中间移动， 且波数减少。 关键词：镁合金；热态内压成形；起皱行为；数值模拟 中图分类号：TG306 文献标识码：A Analysis of wrinkling behavior in warm hydroforming of magnesium alloy tube TANG Ze-jun, YUAN Shi-jian, LIU Gang (School of Materials Science and Engineering, Harbin Institute of Technology, Harbin 150001, China) Abstract: The deformation mechanism was analyzed for an AZ31B magnesium alloy tube in warm hydroforming process by numerical simulation and plasticity theory. The critical wrinkling stress, the stress state and the shape of the wrinkles were obtained. It is shown that the yielding strength and the elastic modulus decrease as the temperature rises, which makes the anti-winkling ability of the tube decrease. The stress loci lie at the zone where the circumstantial strain elongates and axial strain is compressive for both the top zone and the bottom zone of the wrinkles wave. The stress at the top zone of the wrinkles wave tends to make the wall thickness thin as the feeding increases. The stress