F550 船板钢中心偏析遗传性研究.pdfVIP

F550 船板钢中心偏析遗传性研究 ·1 · F550 船板钢中心偏析遗传性研究 1 1 2 1 季益龙 刘建华 陈 方 刘 建 （1. 北京科技大学冶金工程研究院，北京 100083 ； 2. 马钢工程技术集团有限公司，安徽马鞍山 243000 ） 摘 要 本研究采用了原位统计分布分析技术，分别对加热处理前后的F550 船板钢铸坯以及轧材中的C、P、S、 Mn 四种元素进行了偏析度分析。实验结果显示，铸坯中心存在着宽度为5mm 左右的偏析带，与Mn 元素相比，P、 C、S 的偏析较为严重；在经过加热处理后，中心偏析得到明显改善，但不能完全消除，这表明中心偏析具有遗传 性；轧制后C、S、P、Mn 的偏析度均得到不同程度改善，其中S、Mn 的偏析趋于消除，但C、P 的偏析带依然明 显，且偏析带宽度由5mm 扩展为10mm。 关键词 F550 船板钢，中心偏析，遗传性，原位统计分布分析 Research on Centerline Segregation Heredity of F550 Shipbuilding Steel 1 1 2 1 Ji Yilong , Liu Jianhua , Chen Fang , Liu Jian (1. Engineering Research Institute, University of Science and Technology Beijing, Beijing 100083, China; 2. Masteel Engineering and Technology Group Limited Company, Maanshan Anhui 243000, China) Abstract In this paper,the technology of original position statistic distribution analysis was applied to analyze the element segregation of C, P, S and Mn in the F550 shipbuilding steel slab before and after heat treatment and rolled-products. The results show that there is a 5mm-thick segregation band in the center of the slab. The segregation of P, C and S is more serious than C. Although the segregation was obviously ameliorated after heat treatment, it could not be eliminated completely by heating. This indicates that centerline segregation is hereditary. After rolling, the segregation was improved in different degree. The band of S, Mn was nearly invisible, while that of C,P was still obvious. And thewidth of the center segreg