单相桥式逆变电路课程方案.docxVIP

《电力电子技术》课程设计说明书 单相桥式逆变电路 院 、 部： 电气与信息工程学院 学生姓名： 高 村 指导教师： 肖文英 职称 副教授 专 业： 电气工程及其自动化 班 级： 电气本1204 完成时间： 2015年6月1日 PAGE \* MERGEFORMATVI 摘 要 随着电力电子技术的高速发展，逆变电路的应用非常广泛，蓄电池、干电池、太阳能电池等都是直流电源，当我们使用这些电源向交流负载供电时，就需要逆变电路。另外，交流电机调速用变频器、不间断电源、感应加热等电力电子装置，其核心部分都是逆变电路。 本设计要做的就是输入100V的直流电压，输出交流电压频率范围在30～60HZ，电压30～50V范围可调。根据电力电子技术的相关知识，把直流电变成交流电的电路成为逆变电路。单相桥式逆变电路是一种常见的逆变电路。采用阻感负载，负载两端的电压即为输出电压。设计电路中采用IGBT作为开关器件，利用ICL8038芯片产生频率符合要求的信号来控制IGBT的通断，从而得到频率范围在30～60HZ的交流电压。采用移相调压来调节输出电压的大小。 关键词： 直流电压；交流电压；逆变；桥式 ABSTRACT With the rapid development of power electronic technology, the inverter circuit has a very wide range of applications, such as battery, battery, solar battery is a dc power supply, when we use the power supply to the ac load power supply, inverter circuit is needed.In addition, the ac motor speed control by frequency converter, uninterruptible power supply, induction heating power electronic devices, such as its core part is the inverter circuit. This design has to do is enter the dc voltage 100 v, output voltage in 30 ~ 60 hz frequency range, 30 ~ 50 v voltage range is adjustable.According to the power electronic technology knowledge, become the inverter circuit of direct current into alternating current circuit.Single-phase bridge inverter circuit is a common inverter circuit.Use resistance load, feeling at the ends of the load voltage is the output voltage.In the design of circuit using IGBT as the switch device, using ICL8038 chip conform to the requirements of the frequency signal to control the on-off of IGBT, frequency range is obtained in 30 ~ 60 hz ac voltage.Phase-shifting surge tank is used to adjust the size of the output voltage. Key words dc voltage；ac voltage；inverter；bridge 目 录  TOC \o 1-4 \h \z \u  HYPERLINK \l _Toc421257084 摘要  PAGEREF _Toc421257084 \h I  HYPERLINK \l _Toc421257085 ABSTRACT  PAGEREF _Toc421257085 \h II  HYPERLINK \l _Toc421257087 课程设计任务书  PAGEREF _To