鼠标D分析报告.pptVIP

XTD中心輪下壓功能串鍵分析報告Pressing the scroll wheel button is also triggered the tilt function to the left issue analysis report * 不良現象：中心輪下壓功能串鍵 Fail phenomena : unbalanced wheel causing for 17 units to accidently press left/right tilt too easily. Prepared by PE: 封陽勝 2012年8月15日 Computer Power Division Analysis Report –August 2012 Computer Power Division 設計5.50mm,實測為5.50-5.55mm在規格內. This area design value of height is 5.50mm, Measured incoming part is 5.50~5.55mm in design spec PCB 設計值1.60mm,实测来料1.64-1.70mm偏規格上限 PCB design value of height is 1.6+-0.1mm Measured incoming part is 1.64~1.7mm close to upper specification limit 設計3.10,实测来料3.123.15mm在规格内 Wheel holder design value is 3.10mm, Measured incoming part is3.12-3.15mm in design spec 设计13.45mm,實測組裝后數值13.42-13.45mm This area design value of height is 13.45mm, Measured assembly height is 13.42~13.45mm Switch设计值高度5.7mm，實測5.66-5.70mm Switch design value of height is 5.7mm，Measured height of switch is 5.66-5.70mm XTD下蓋組裝主要參數值及來料測量數據，以下為3D示意圖：以下參考數據發現只有主板PCB厚度為上限值，影響到中心論下壓功能串鍵，有對開關造成預壓，會使問題出現。 The main parameters value and the incoming measured data the XTD bottom cover assembly (refer as below drawing): From as data -the main PCB thickness close to spec upper limit to impact the wheel under the pressure function string key, switch preload will make the problem appear. Bottom of the lower cover to switch, the height of combination of design value = 5.50 +1.60 +5.70 = 12.80mm Bottom of the lower cover to switch of incoming part ,combination of the measured maximum value = 5.55 +1.70 +5.70 = 12.95mm, Measurement 10pcs average is 12.90mm, calculate the value from the point of view Switch has been preloading, when the wheel under the heavy pressure cause string key。 Analysis Report –August 2012 Computer Power Division The center wheel under pressure function string, Root Cause Analysis: