模具设计DFM模板..pptVIP

擦穿位置分析 Shut off position Customer comment. (please give your approval and comments) Date Approval by: Remark OK or NG 此面插穿角不够，需修到3度 产品出模分析 Product Draft analysis Customer comment. (please give your approval and comments) Date Approval by: Remark OK or NG Draft analysis Draft OK 产品料厚分析 Product Thickness analysis Customer comment. (please give your approval and comments) Date Approval by: Remark OK or NG 产品胶料厚度均匀 产品光洁度标准 NO Texture 请提供光洁度标准 Customer comment. (please give your approval and comments) Date Approval by: Remark OK or NG 1、版本号我司做镶针，相关的字体我司默认为晒字，深0.2MM，凸字。 日期镶件（年月一起） Engraving