马鞍山市限制燃放烟花爆竹管理规定 T.pptVIP

1/5/2007 2007 FIRST Rookie Workshop Building a Chassis Building a Chassis Building a Chassis Advantages: lightweight, quick to build, uses standard parts Disadvantages: may not fit your design, requires added structure (that will most likely be put on anyway) Building a Chassis Advantages: quick to build, standard parts, easy to create tension and to add fastening points Disadvantages: heavy, expensive Building a Chassis Advantages: lightweight, strength, fits your design Disadvantages: takes time, requires skill, non standard parts Building a Chassis Advantages: fits your design, unique Disadvantages: takes much time, requires skill, non standard parts Building a Chassis Aluminum Extrusion 1/16” – 1/8”: usable but will dent and bend T-slot: use 1” sized profiles or higher Aluminum Plate, Bar, and Angle 3/16” – ?” used often Plastic Sheet Spans structures, provides bracing Polycarbonate (LEXAN, etc.) NOT Acrylic (Plexiglas, etc.) Wood Lightweight and easy to use Will splinter and fail but can be fixed Steel Tube and Angle Strong, but heavy, 1/16” wall thickness is plenty strong Misc Extruded fiberglass, PVC tubing, etc. Use your imagination! Building a Driveline Building a Driveline Building a Driveline Building a Driveline Building a Driveline Building a Driveline Building a Driveline What’s in the KOP What’s in the KOP * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * Building a Driveline Supporting Shafts motor Building a Driveline Supporting Shafts motor Building a Driveline Supporting Shafts motor Building a Driveline Supporting Shafts motor Building a Driveline Supporting Shafts Building a Driveline Supporting Shafts Building a Driveline Supporting Shafts Building a Driveline Supporting Shafts Building a Driveline Supporting Shafts Building a Driveline Supporting Shafts ONLY IF SHAFT IS SHORT Building a Driveline Shaft Support Recommendations Never side-load y