油水分离器JOWA 3SEP OWS PLC latest PROGRAM中文说明.pdf

Settings To select and adjust settings, pr ess key “Down/6” When a figure in display flashes, this value can bee adjusted. After new value has been inserted, press Enter button. Step in Menu with up/down/left/right arrows. Alarm’s OWS Alarm trigged every time power has been shut down. Reset Alarm to start OWS in “Stand By Mode” Alarm trigged when pump motor has been over heated Check that OWS pump is running without disturbings. Alarm trigged when flow to OWS is missing. Check pipe and valves in suction pipe. Alarm trigged when still high ppm after recirculation time is run out. Status is high ppm alarm Alarm trigged after set “long run time” is reached Alarm trigged when over heating protection relay is activated. Check if heater is on when no water in tank. V01 has been open longer than set time. Check if there is Water, Oil or Air in tank T1 ~PV:002 = Air in tank T1 ~PV:040 = Oil in tank T1 Circulation Pump has been running longer than set time. Check flow, level in tank, stop in pipe, valves on pipe. Transfer Pump is restarted inside set time limit. Check for leaks to transfer tank Information Displayes Is displayed when V01/Tank 1 makes oil release When OWS Pump is stopped, OWS makes a drop of system pressure to avoid unnecessary flow in sample line. Outlet flow from T3 trough V04 is changed to V05 when high ppm Observe, this is no “High ppm Alarm” status