PECO钢嘴1.ppt

Fish tail might be caused by various reasons such as machine, wire, parts, and hard L/F. We focus on capillary design to compensate of bonding problems caused by high frequency wire bonding machine and rough surface of L/F. In order to remove “fishtail” problem with using PECO Capillary, 1. Make thinner 2nd stitch with either increasing the parameters or decreasing Face Angle. PECO recommend to apply the lower FA in Nipd frame.but usually High FA is necessary for other package in order to make thick stitch 2. Better to have a sharp interconnection between CD and FA. In order to do so either you could decrease ICA from 90 to 70 or avoid OCP design. 3. Matte finish will increase power transfer but would lower the lifetime. So it is not recommendable. ? ?? ??? ?? ??? HIGH FREQUENCY BONDING  Prepared By RD Dept. Lead frame High frequency Lead frame Low frequency capillary capillary HIGH FREQUENCY BONDING MAJOR BONDING PROBLEM WITH HIGH FREQUENCY High Frequency Bonding Could cause Several Bonding Problem Short Tail Problem Peeling Problem(Fish Tail Problem) NSOL Problem Impedance Issue Etc. The other main reasons of wire tail problem. 1. Wire problem -Wire is too old. -Excessive wire elongation. 2. Lead frame -Lead frame is not planar. -Dust or other attached contamination on Lead frame. -Bouncing on L/F 3. Capillary -ICA size is too big( too shallow like 120 Deg.). -Too shallow interconnection between CD and FA -Too big CD size or too small CD size 4. Other possible reason -Caused by contamination. -Very good bondibility of metalization