哈尔滨汽机厂20131113胜科访问报告.ppt

1#机组高中压转子， 加工轴颈后回厂，预计11月25日从韩国发出。 1# unit HIP rotor will be arrived in HTC after bearing journal manufacturing is finished. It is planned to deliver from Korea on November 25. 1#机组高中压外缸上半已到厂，待检验合格后立即投料 Raw material of 1# unit HIP outer casing upper half has purchased, and manufacturing will start after material check is qualified. 1#机组高中压外缸下半已到厂，待检验合格后立即投料 Raw material of 1# unit HIP outer casing lower half has purchased, and manufacturing will start after material check is qualified. 1#机组低压内缸已加工完成 1# unit LP inner casing manufacturing has completed 1#机组低压外缸已加工完成 1# unit LP outer casing manufacturing is completed 1#机组低压外缸已加工完成1# unit LP outer casing manufacturing is completed 1#机组低压外缸已加工完成 1# unit LP outer casing manufacturing is completed 1#机组低压外缸已加工完成 1# unit LP outer casing manufacturing is completed 1#机组低压外缸已加工完成 1# unit LP outer casing manufacturing is completed 1#机组低压外缸已加工完成 1# unit LP outer casing manufacturing is completed 1#机组3#轴承箱已加工完成 3# bearing box manufacturing of 1# unit is completed 1#机组4#轴承箱已加工完成 4# bearing box manufacturing of 1# unit is completed 2#机组1#低压转子，预计2013年12月底到厂 LP rotor 1# of unit 2# will be arrived in HTC in December 2013. 2#机组2#低压转子，预计2013年12月底到厂 LP rotor 2# of unit 2# will be arrived in HTC in December 2013. 2#机组高中压外缸上半，预计2013年12月底到厂 HIP outer casing upper half of unit 2# will be arrived in HTC in the end of December. 2#机组高中压外缸下半，预计2013年12月底到厂 HIP outer casing lower half of unit 2# will be arrived in HTC in the end of December. 2#机组高中压转子，加工轴颈后回厂，预计2013年12月底从韩国发出。 2# unit HIP rotor will be arrived in HTC after bearing journal manufacturing is finished. It is planned to deliver from Korea on end of December. 项目的其他部件生产情况： Manufacturing Status of other components 1#、2#地脚螺栓、锚固板及预埋件均已发货； Anchoring bolts, anchoring plates, and embedded parts have already been dispatched. 1#机组凝汽器：管板已经到货，正在备料；低加正在备料； Condenser of 1# unit: tube plate arrived in HTC, and ready for manu