轮机英语三管轮试题 甲板机械.docVIP

1907. _____ are used to handle anchors and chains. A. Cargo winches B. Mooring winches C. Windlasses D. Cargo hatches 1908. _____ are used for hauling in or letting out the wires which fasten the ship to the shore. A. Cargo winches B. Mooring winches C. Windlasses D. Cargo hatches 1909. _____ unit is mounted so as to raise and lower the cable from the spurling pipe, which is at the top and center of the chain or cable locker. A. The cable lifter B. The hoisting motor C. The topping wire D. The life-raft 1910. _____, or drum is used for hauling in or letting out the wires or ropes which will fasten the ship to the shore. A. The winch motor B. The band brake C. The winch barrel D. The anchor capstan 1911. The_____ is used for hauling in or letting out the wires or ropes. A. windlass B. anchor capstan C. turning gear D. winch barrel 1912. Anchor_____ are used in some installations where the cable lifter rotates about a vertical axis. A. windlasses B. drums C. capstans D. warp ends 1913. Anchor capstans are used in some installation where the cable lifter rotates about a _____. A. horizontal axis B. crankshaft C. vertical axis D. camshaft 1914. In the cargo winch, spur reduction gearing transfers the motor drive to_____. A. the toping light B. the board brake C. the fail-safe D. the barrel shaft 1915. If an anchor windlass has been idle for some time, you should_____. A. repack all valve stems B. lubricate it prior to use C. replace the foundation bolts D. balance the warping heads 1916. If the pump for a hydraulic anchor windlass is over heating, the cause may be_____. A. increased pump speed B. excessive pump discharge pressure C. too low of a tilting box angle D. low pump speed 1917. The part of the anchor windlass that engages the anchor chain for lifting is called the _____. A. warping head B. fairlead C. wildcat D. capstan 1918. If the pump for a hydraulic anchor windlass is overheating, the cause