派士数控转台技术文件AWUP160技术协议中英文-吴.doc

The Technical Agreement 技术协议 1. NC Rotary Table, type: AWUP160 , with Counterbearing: GGP160 数控回转工作台, 型号:AWUP160; 及，尾座，型号：GGP160 转台加尾座统一命名为: WWUP160 1. 1Technical Description 技术描述 1.1 .1 Execution of table platen台面 Table platen manufactured from Meehanite GGG cast-iron, which is hydraulic tight and also gives highest rigidity - Ground clamping surface, precisely machined 工作台台面采用德国米汉纳GGG高等级铸铁，具有非常高的刚性。 夹紧面采用精密的机械加工完成。 1.1.2 Base 底座 The base casting is manufactured from Meehanite GGG cast-iron, which is hydraulic tight and also gives highest rigidity and stiffness. - supporting surface precisely machined - equipped with clamping slots/fixing holes - body bottom prepared to be installed the clients machine 工作台底座采用德国GGG高等级铸铁，具有非常高的刚性，采用独特的液压夹紧技术具有夹紧速度快，扭矩大， 制动性强，平稳性高，抗倾覆力矩强的特点。 支撑面采用了精密机械加工完成。 配置有夹紧槽或安装孔。 工作台底座通过螺丝螺母安装在客户机床上 1.1.3 Drive 驱动 The table will be driven by servo motor of clients We are using worm and wheel sets from company Ott which have the highest accuracy that is available in the market. It also has a patent pended zero backlash adjusting system, where you can set backlash to zero with any disassembly of the worm 工作台驱动的伺服电机由客户自己提供。 转台由伺服电机驱动德国OTT 涡轮双蜗杆，具有极高的精度, OTT涡轮蜗杆为 可调隙的德国专利技术，维护非常方便 1.1.4 Bearing 轴承 The table is centrally supported by high precision preloaded axial - radial bearing from company INA which gives highest stiffness to the faceplate. 工作台的中心支撑采用德国INA公司生产的高精确的轴向-径向转台专用YRT轴承，保证了转台的高刚性及大承重。 1.1.5 Lubrication 润滑 the bearing are running in--- Oil lubracation. 轴承采用油润滑形式。 1.1.6 Sealing 密封 Precautions are taken to prevent entrance of dust, chips and coolant into the inside of the table. There is also an air purge foreseen on the housing; so there is a permanent overpressure of 0,2 bars onto the housing which prevents that dust or chips are entering the table. (client must give 6 bar to our connection) 为了预防粉尘，细削和冷却液进入工作台内部，在外壳上有一个空