通用可靠性测试指引(General reliability test instruction).docVIP

通用可靠性测试指引 (General reliability test instruction) 制作人(Prepare By) ： David Tsang 批准人(Approve By）： Carrie Chueng 发出日期(Issue Date)： Aug. 05, 2010 1. 目的(Purpose) 根据一般行业标准的可靠性测试要求及判定基准, 本文件旨在建立可靠性的一些测试项目、要求和操作说明来规范和指导PDP业务的可靠性。 (Basing on the general reliability test requirements and judgment criteria in industrial standard, this document aims to set up the some test items, requirements and operation instruction for standardization of reliability test of PDP business). 2. 适用范围(Scope) 本程序文件适用于与PDP有业务的产品. 如顾客没有提供测试标准或产品本身无特别安全测试要求,PDP及生产商可根据本程序内文的测试标准或指定的文件来进行可靠性测试。 (This document is applicable to the products which related to PDP business. PDP and subcontractor can conduct reliability test referring to this instruction if no specified testing instruction supplied by customer.) 3. 参考文件(Reference) 3.1 产品规格 (Product specification) 3.2 电气规格（Available electrical specification） 3.3 QP-RTI-002 (NOA Accessory Testing Guideline) 4. 操作程序(Operation Procedure) 4.1 首先根据产品的物料特性、设计的要求选取下面合适的测试项目进行测试。 （First select suitable reliability test items in this document to fulfill the reliability test according to the material feature and design requirement of products） 4.2 部分测试项目只需要某个部件即可，不需整个产品或配件。 （Some test items may need a certain component/parts only, not whole product or accessory to achieve） 4.3 对于部分测试项目，除了产品要达到最低要求以外，还需提高测试要求去测试，反映产品的实际情况，特别是在设计试产阶段。 （For some test items, the products not only meet the low limit requirement, but also test them with tightened requirements of reliability test to show the actual quality of the products for monitoring, especially the products are in initial development and pilot run stage） 4.4 测试员记录有关测试数据，完成可靠性测试后，发出测试报告。 （Operator obtain and record relative test data and release reliability test report after completed test） 5. 可靠性测试项目及要求（ Reliability test items and requirements） 5.1 环境测试（Environment test） a. 低温储存测试(Low temp storage te