ABB公司 800xA 北京培训资料5 Trace variables and Searching.doc

Trace variables and Searching TABLE OF CONTENTS Chapter 4 Trace variables and Searching 4-i Chapter 4 Trace variables and Searching 4-1 4.1 General Information 4-1 4.1.1 Description 4-1 4.1.2 Objectives 4-1 4.2 Lesson 4.1 – Methods for searching and tracing 4-2 4.2.1 Lesson 4.1.1 – Search a variable within a program 4-3 4.2.2 Lesson 4.1.2 – Search a global variable within an application 4-5 4.2.3 Lesson 4.1.3 – Trace signal from I/O to process graphics 4-7 4.2.4 Lesson 4.1.4 – Trace signal from Alarm list to I/O 4-13 4.2.5 Lesson 4.1.5 – Trace signal from Process Graphics to I/O 4-17 4.2.6 Lesson 4.1.6 – Search and navigate in Process Portal 4-18 4.2.7 Description 4-18 4.2.8 Search and Navigate 4-18 4.3 Exercise 4.1 – Trace a variable through the system 4-22 4.4 Lesson 4.2 – Trouble shoot alarm problems and programs 4-22 4.4.1 Description 4-22 4.4.2 Step into code 4-22  Trace variables and Searching General Information Description This chapter gives you an overview how to trace variables and trouble shoot programs. Objectives Upon completion of this chapter, you will be able to: Search for a variable within a program. Use a cross reference list generated by the bulk data manager. Follow signal from an I/O channel to the program source. Trouble shoot programs concerning alarm problems. Different ways to search and navigate. Lesson 4.1 – Methods for searching and tracing Different trace and search methods must be applied depending on the scope for your search and trace. Search within a programming organizational unit is described in chapter 4.2.1 . The chapter describes also how you follow a signal. Search within an application is described in chapter 4.2.2 . The example shows how to use the cross reference sheet application.  Trace signal from I/O to Application and Process Graphics is described in chapter 4.2.3 . Trace a signal from an alarm list to I/O definition is described in 4.2.4 . Trace a signal from process graphics to I/O definition is de