基本配置和静态配置.docx

实验3 路由器配置实验之基本配置和静态配置实验过程及结果：router-a（config-if）#outer Con0 is now availablePress RETURN to get started.RouterenRouter#config tEnter configuration commands, one per line. End with CNTL/Z.Router(config)#enable secret 1234Router(config)#enable password 1234Router(config)#line console 0Router(config-line)#loginRouter(config-line)#password1234% Invalid input detected at ^ marker.Router(config-line)#password 1234设置路由器A：Router Con0 is now availablePress RETURN to get started.RouterenRouter#config tEnter configuration commands, one per line. End with CNTL/Z.Router(config)#hostname Router AA(config)#Hostname Router-ARouter-A(config)#int e0Router-A(config-if)#ip address 172.16.10.1 255.255.255.0Router-A(config-if)#no shut%LINEPROTO-5-UPDOWN: Line protocol on Interface Ethernet0, changed state to up%LINK-3-UPDOWN: Interface Ethernet0, changed state to upRouter-A(config-if)#int s0Router-A(config-if)#ip address 172.16.20.1 255.255.255.0Router-A(config-if)#no shut%LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0, changed state to up%LINK-3-UPDOWN: Interface Serial0, changed state to upRouter-A(config-if)#int t0% Invalid input detected at ^ marker.Router-A(config-if)#int T0% Invalid input detected at ^ marker.Router-A(config-if)#int t0% Invalid input detected at ^ marker.Router-A(config-if)#int s0Router-A(config-if)#clock rate 64000%Error: This command applies only to DCE interfacesRouter-A(config-if)#int Token Ring 0% Invalid input detected at ^ marker.Router-A(config-if)#interface ethernet 0% Invalid input detected at ^ marker.Router-A(config-if)#^z% Invalid input detected at ^ marker.Router-A(config-if)#int to0Router-A(config-if)#ip address 172.16.15.1 255.255.255.0Router-A(config-if)#no shut% TokenRing0: no ring speed has been setRouter-A(config-if)#后保存：Router-A Con0 is now availablePress RETURN to get started.Router-AenRouter-A#copy run startBuilding configuration...[OK]Router-A#设置路由器B：Router Con0 is now availablePress RETURN to get started.RouterenRouter#config tEnt