Juniper Junos SRX系列Cluster HA配置汇总.docxVIP

1.插线指定主备On device A: set chassis cluster cluster-id 1 node 0 rebootOn device B: set chassis cluster cluster-id 1 node 1 reboot定义控制层端口 （可配置网管口）On device A:{primary:node0}set groups node0 system host-name HQ-CS-FW-SRX550-1set groups node1 system host-name HQ-CS-FW-SRX550-2set apply-groups ${node} //必配-----------------?set groups node0 interfaces fxp0 unit 0 family inet address ip address/mask?——Device As management IP address on fxp0 interface?set groups node1 interfaces fxp0 unit 0 family inet address ip address/mask?——Device Bs management IP address on fxp0 interface----------------配置网管地址各设备型号控制线端口?SRX Series Chassis Cluster Slot Numbering, and Physical Port and Logical Interface Naming4.定义数据层端口On device A:{primary:node0}-fab0 is node0 (Device A) interface for the data link# set interfaces fab0 fabric-options member-interfaces ge-0/0/2-fab1 is node1 (Device B) interface for the data link# set interfaces fab1 fabric-options member-interfaces ge-9/0/25.配置 redundancy-group{primary:node0}set chassis cluster redundancy-group 0 node 0 priority 100set chassis cluster redundancy-group 0 node 1 priority 50set chassis cluster redundancy-group 1 node 0 priority 100set chassis cluster redundancy-group 1 node 1 priority 50注： Redundancy Group 0 for the Routing Engine failover properties 必配?Redundancy Group 1 to define the failover properties for the Reth interfaces (all the interfaces will be in one Redundancy Group in this example) 建议所有端口放一个Group6. 配置 端口监控On device A:{primary:node0}set chassis cluster redundancy-group 1 interface-monitor ge-0/0/3 weight 255set chassis cluster redundancy-group 1 interface-monitor ge-0/0/4 weight 255set chassis cluster redundancy-group 1 interface-monitor ge-9/0/3 weight 255set chassis cluster redundancy-group 1 interface-monitor ge-9/0/4 weight 255注：监控所有端口 Interface monitoring is not recommended for redundancy-group 0.7.配置 Reth interface 并划入 zoneConfigure the Redundant Ethernet interfaces (Reth interface) and assign the Redundant interface to a z