除湿器试验程序(船东).doc

注：此试验程序仅供参考，所有问题解释权为制造厂服务工程师。 Note: the procedure is only for reference. Any question’s explaining Right attributes the service engineer of the manufacturer. 5200RoRo Car/High Heavy Vehicle Carrier HULL NO: JLZ020401 Dehumidifier test procedure 除湿器试验程序 JL3173-946-03SY-04 COMPILED COPIED CHECKED STAN.CONTR SHEET 1 OF 4 CONFIRMED JingLing Shipyard APPROVED DATE 一、 Inspection for Running Unit 除湿系统的单机运行检查： Connecting main power to the unit, operating the switch to the “1”position and ensure that the power connected indicator should illuminate. 给机组送电并将主电源隔离开关置于1位置，此时机组的电源指示灯应该亮起。 Operating the run/stop switch to the “MAN” position and checking that following indicators are on: 将机组的状态开关置于MAN位置，除湿机操作面板上应亮起以下指示灯： # Power connected indicator # 电源连接指示灯。 # Unit running indicator # 机组运行指示灯。 # Both reactivation heater indicator # 再生加热器工作指示灯 # Process and reactivation air fan indicator # 处理空气风机和再生空气风机的运行指示灯。 # Drive motor indicator ＃驱动马达运行指示灯。 After the unit is running, the reactivation heater should work, and the panel of unit can show that the reactivation temperature is rising. 机组运行后，确认加热器运行，除湿机操作面板显示加热空气温升。 When the run/stop switch are the “o” position, the unit has been shut off, and the reactivation fan will continue to run, until the temperature has fallen below 50C 0, then the unit stop automatically. 将状态开关置于0位置，除湿机关机，再生风机应继续运行，一直到再生空气温度降 至50℃以下，自动停止. 二、Airflow Adjustment in System 除湿系统风量调节： Airflow adjustment of dehumidify system 除湿系统的风量调节： Start the dehumidifier and supply fan. 启动除湿机和送风机. Testing the reactivation airflow on site from the pre-made test-holes on the duct. Adjust the reactivation airflow to rated value by adjusting the damper. Locking and Marking the damper while the airflow is ok. 使用现场测试仪器检测再生风量（风管上应有预留的测试孔），通过调节再生空气阀门， 使再生风达到额定要求；风量正确后，将阀门锁定于该位置，并标注。 Testing the outlet airflow of the supply fan adjusting it to the rated v