燃煤电站工程 厂用电切换系统调试方案.doc

BALCO EXPANSION PROJECT 4×300 MW THERMAL POWER PLANT Procedure of Auxiliary Power Change-over Test 印度BALCO扩建4×300MW燃煤电站工程 方案 . 2009 2010年月 Compiled by 编写：_______________ Revised by： 审核：Approved by： 批准：CONTENTS 1. 试验目的 Purpose 2. 试验范围 Scope of test 3. 系统及设备参数Specification of major equipment 4. 试验前应该具备条件 Prerequisites of test 5. 试验步骤 Test procedure 6. 注意事项 Safety precautions 1. 目的Purpose 1.1检查电气保护、联锁、信号和厂用电源切换装置设备等，确认其动作可靠。检查设备的运行情况和系统的性能，发现并消除可能存在的缺陷。保证系统和设备能够安全正常地投入运行。 Check and confirm the protection, interlock, signal, change-over devices and so on. Confirm the action must be reliable. Check equipment operation and system performance. Discover and then eliminate the defect might exist. Ensure the system and equipments can be put into operation safely. 2. 试验范围Test scope 2.1 6KV单元段1SA(2SA)带负荷切换 On-load change-over test of 6KV unit board 1SA（2SA） 2.2 6KV单元段1SB(2SB)带负荷切换 On-load change-over test of 6KV unit board 1SB（2SB） 2.3 6KV 公用段1A(2A)带负荷切换 On-load change-over test of 6KV common service board 1A(2A) 2.4 6KV 公用段1B(2B)带负荷切换 On-load change-over test of 6KV common service board 1B(2B) 3.试验前应具备的条件：Prerequisites before test Electric and I/C prerequisites 3.1.16KV工作、公用段工作进线、开关传动试验完毕，结果正确。 Transmission test of switches must be completed and correct. 3.1.2厂用电源快切装置静态调试完毕，各整定值已按定值通知单执行，且具备投运条件。 Static test of auxiliary power change-over device must be complete and fulfill the operation requirement. Set-value must be implemented as per requisition. 3.1.3 A高厂变、#2启备变所有保护已投入。 All protections of unit transformers A 、#2 station transformer must be put into operation. 3.1.4 A高厂变、#2启备变冷却器已投入。 All cooler system of unit transformers 、#2 station transformer must be put into operation. 3.1.5电气和热控的有关表计经过校验，指示正确。 Related electric and IC gauges must be calibrated and correct indication. 3.1.6电气和热控的保护、联锁、控制和信号传动试验完成，试验结果正确。 Protections, interlock, control and signal transmission test of electric and IC must be complete and correct. 3.2.1 试运现场道路畅通，照明充足，事故照明可靠。 Roads of trial r