特高压变压器用硅钢片应用磁性能的评价-中国电机工程学报.pdfVIP

第37 卷 第18 期 中 国 电 机 工 程 学 报 Vol.37 No.18 Sep.20, 2017 2017 年9 月20 日 Proceedings of the CSEE ©2017 Chin.Soc.for Elec.Eng. 5511 DOI ：10.13334/j.0258-8013.pcsee.162558 文章编号：0258-8013 (2017) 18-5511-08 中图分类号：TM 85 特高压变压器用硅钢片应用磁性能的评估 张书琦，李鹏，徐征宇，汤浩，李金忠，仇宇舟，刘雪丽 ( 中国电力科学研究院，北京市 海淀区 100192) Assessment on Applied Magnetic Properties of Silicon Steel Sheet in UHV Transformer ZHANG Shuqi, LI Peng, XU Zhengyu, TANG Hao, LI Jinzhong, QIU Yuzhou, LIU Xueli (China Electrical Power Research Institute , Haidian District, Beijing 100192, China) ABSTRACT: IEC 60404 just specified the test methods on 心模型，直流偏磁电流大于 1.0A 后该趋势更加明显；反复 magnetic properties of single silicon steel sheet, and it was 过励磁条件下试样Ⅱ铁心模型空载电流及空载损耗波动范 difficult to meet the requirements of the applied magnetic 围较大，反复过励磁前后空载损耗变化率较小。最后，提出 properties of silicon steel sheet for UHV Transformer. 了适用于特高压变压器用硅钢片应用磁性能的 8 项评估指 Therefore, applied magnetic properties test system for silicon 标，分析结果认为，试样Ⅰ及试样Ⅱ铁心模型在应用磁性能 steel sheet based on iron core model was established, and the 方面差别明显。研究结论为技术人员掌握硅钢片应用磁性能 characteristics included deep magnetic saturation, DC bias 提供了新思路。 tolerance and repetitive excitation were studied by comparing 关键词：特高压变压器；硅钢片；应用磁性能；深度磁饱和； two kinds of silicon steel sheet iron model. The results show 耐受直流偏磁；反复过励磁；评估 that, the no-load current of Sample II iron core model is significantly greater than Sample I during the range of 0 引言 100%~115% rated voltage, and harmonic current content