JUNOS命令行操作界面.pptVIP

Updated 8/22/00 Juniper Networks, Inc. Copyright ? 2000 - Proprietary Confidential JUNOS CLI Juniper Conventions JUNOS always uses CIDR notation = /8 = /16 = /24 28 = /25 52 = /30 55 = /32 “set interfaces ge-1/0/0 unit 0 family inet address /24” “set routing-options static route /30” Juniper Interfaces Each router has two permanent interfaces: fxp0 out-of-band management interface fxp1 Internal Ethernet interface. Connects the route engine to the PFE Juniper Interfaces Loopback Interface lo0 Loopback zero On the router, you can configure one physical loopback interface, lo0, and one or more addresses on the interface. Interface Names Physical interfaces have standard names Type FPC slot PIC slot Port number Juniper Interface Naming type-fpc/pic/port.logical Type - The interface name, which defines the media type FPC - The slot in which the FPC is located PIC - The location on the FPC in which the PIC is installed The PIC port The interface’s channel and logical unit numbers 0-16384 (optional) so-0/0/1.0 POS interface on FPC 0, PIC 0, port 1 Unit 0 Logical interface descriptors Logical interfaces are used to set up Frame Relay DLCIs, ATM virtual circuits, or VLANs so-5/2/3.43 Interface number is separate in meaning from the actual DLCI, ATM VC, or VLAN and can be any arbitrary value Suggested convention is to keep them the same whenever possible Ways to access the router Console/Aux Port telnet ssh1/ssh2 For security reasons, no remote access to the router is enabled by default. You must configure the router explicitly so that users on remote systems can access it. Authentication using TACACS+ or RADIUS Separate login, authentication, and permissions for each user can also be administered locally Operational Mode CLI - Like Cisco enable Command Line Interface The CLI is indicated by the presence of the prompt it is preceded by a string that defaults to the name of the user and the name of the router. For example: user@host Command line co