F2812的C语言处理中断.docVIP

F2812的C语言处理中断 关于F2812中用C语言来实现中断的说明： 1.首先在.cmd中定位系统中断表： MEMORY { PAGE 0 : PAGE 1 : PIE_VECT : origin = 0x000D00, length = 0x000100 } SECTIONS { PieVectTable : PIE_VECT, PAGE = 1 } 2.在C中制定该中断的结构体： #pragma DATA_SECTION(PieVectTable,PieVectTable); struct PIE_VECT_TABLE PieVectTable;（在DSP28_GlobalVariableDefs.C中初始化） 3.用一组常数（按照中断向量的顺序）初始化该名字为PIE_VECT_TABLE的表： typedef interrupt void(*PINT)(void);这里有些一问，一下应该为函数名？？ // Define Vector Table: struct PIE_VECT_TABLE { // Reset is never fetched from this table. // It will always be fetched from 0x3FFFC0 in either // boot ROM or XINTF Zone 7 depending on the state of // the XMP/MC input signal. On the F2810 it is always // fetched from boot ROM. PINT PIE1_RESERVED; PINT PIE2_RESERVED; PINT PIE3_RESERVED; PINT PIE4_RESERVED; PINT PIE5_RESERVED; PINT PIE6_RESERVED; PINT PIE7_RESERVED; PINT PIE8_RESERVED; PINT PIE9_RESERVED; PINT PIE10_RESERVED; PINT PIE11_RESERVED; PINT PIE12_RESERVED; PINT PIE13_RESERVED; // Non-Peripheral Interrupts: PINT XINT13; // XINT13 PINT TINT2; // CPU-Timer2 PINT DATALOG; // Datalogging interrupt PINT RTOSINT; // RTOS interrupt PINT EMUINT; // Emulation interrupt PINT XNMI; // Non-maskable interrupt PINT ILLEGAL; // Illegal operation TRAP PINT USER0; // User Defined trap 0 PINT USER1; // User Defined trap 1 PINT USER2; // User Defined trap 2 PINT USER3; // User Defined trap 3 PINT USER4; // User Defined trap 4 PINT USER5; // User Defined trap 5 PINT USER6; // User Defined trap 6 PINT USER7; // User Defined trap 7 PINT USER8; // User Defined trap 8 PINT USER9; // User Defined trap 9 PINT USER10;