单片机实验二NVIC中断实验.docx

实验二NVIC中断实验 班级: 计科0902 学号:名: 万晓松实验目的STM32 中断的基本概念以及嵌套向量中断控制器(NVIC)。了解中断的优先处理权。读懂所给C语言控制中断代码，学会应用STM32的库函数实验内容理解中断概念，通过实验现象理解代码及函数调用。实验代码及解释EXITMain.c*******************************************************************************/void GPIO_Configuration(void){ GPIO_InitTypeDef GPIO_InitStructure; /* Configure PC.06 as Output push-pull */ GPIO_InitStructure.GPIO_Pin = GPIO_Pin_6; //初始化GPIO_Pin_6，速度为50MHz，为输出 GPIO_InitStructure.GPIO_Speed = GPIO_Speed_50MHz; GPIO_InitStructure.GPIO_Mode = GPIO_Mode_Out_PP; GPIO_Init(GPIOC, GPIO_InitStructure); /* Configure PB.09 as input floating (EXTI Line 9) */ GPIO_InitStructure.GPIO_Pin = GPIO_Pin_9; //初始化GPIO_Pin_9，为中断线9，为输入 GPIO_InitStructure.GPIO_Mode = GPIO_Mode_IN_FLOATING; GPIO_Init(GPIOB, GPIO_InitStructure);}/*******************************************************************************/******************************************************************************** Function Name : NVIC_Configuration* Description : Configure the nested vectored interrupt controller.* Input : None* Output : None* Return : None*******************************************************************************/void NVIC_Configuration(void){ NVIC_InitTypeDef NVIC_InitStructure; #ifdef VECT_TAB_RAM /* Set the Vector Table base location at 0*/ NVIC_SetVectorTable(NVIC_VectTab_RAM, 0x0); #else /* VECT_TAB_FLASH */ /* Set the Vector Table base location at 0*/ NVIC_SetVectorTable(NVIC_VectTab_FLASH, 0x0);#endif /* Configure one bit for preemption priority */ NVIC_PriorityGroupConfig(NVIC_PriorityGroup_1); /* Enable the EXTI9_5 Interrupt *//* 配置外部中断 EXTI9_5 */ NVIC_InitStructure.NVIC_IRQChannel = EXTI9_5_IRQChannel; NVIC_InitStructure.NVIC_IRQChannelPreemptionPriority = 0;//抢占优先级为0 NVIC_InitStructure.NVIC_IRQChannelSubPriority = 0;//响应优先级位0，优先级最高，最先处理 NVIC_InitStructure.NVIC_IRQChannelCmd = ENABLE; NVIC_Init(NVIC_InitStructure);}It.c***********************************************