new led dmx tube外语英文电子书.pdfVIP

NEW LED DMX TUBE INTRODUCTION Thank you for having chosen the item. You will see you have acquired a powerful and versatile device. Unpack your item. Before you initial start-up, please make sure that there is no damage caused by transportation. Should there be any, consult your dealer and do not use the device. SAFETY INSTRUCTIONS Be careful with your operations. With a dangerous voltage you can suffer a dangerous electric shock when touching the wires! Unplug mains lead before opening the housing! IP65 standard, can be used both indoors and outdoors For your own safety, please read this user manual carefully before you initial start-up. If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The arising condensation water might damage your device. Leave the device switched off until it has reached room temperature. Never let the power-cord come into contact with other cables! Handle the power-cord and all connections with the mains with particular caution! Make sure that the available voltage is not higher than stated on the rear panel. During the operation, the housing becomes very hot. Do not switch the device on and off in short intervals as this would reduce the lamp’s life. Never look directly into the light source, as sensitive persons may suffer an epileptic shock (especially meant for epileptics)! Keep away from children and amateurs! . This product is designed for indoor use only. This device is designed for professional use, e.g. on stages, in discotheques, theatres etc. The minimum distance between light-output and the illuminated surface must be more than 0.5 meters. Always fix the fixture with an appropriate safety-rope. The maximum ambient temperature ta = 45° C must never be exceeded. Operate the device only after having become familiar with its functions. Features Controllable via LED DMX tube controller, can run under DMX 512 protocol with