基于52单片机的酒店标准房设计的C程序.docxVIP

程序:#include reg52.h#include intrins.h#define uint unsigned int#define uchar unsigned chartypedef unsigned char BYTE;#define TX_ADR_WIDTH 5 // 5 bytes TX(RX) address width#define TX_PLOAD_WIDTH 20 // 20 bytes TX payload#define RX_PLOAD_WIDTH20// SPI(nRF24L01) commands #define READ_REG 0x00 // Define read command to register #define WRITE_REG 0x20 // Define write command to register #define WR_TX_PLOAD 0xA0 // Define TX payload register address #define FLUSH_TX 0xE1 // Define flush TX register command #define REUSE_TX_PL 0xE3 // Define reuse TX payload