网络变压器模块可靠性测试规格书_LAN Transformer Specification - 精华网络变压器模块可靠性测试规格书_LAN Transformer Specification - 精华.pdfVIP

网络变压器模块可靠性测试规格书 10Sept.2011, Rev. B LAN TRANSFORMER MODULAR SPECIFICATION 网络变压器模块可靠性测试规格书 LAN TRANSFORMER MODULAR SPECIFICATION 1. 范围 Scope 该标准涵盖了网络变压器模块(包含百兆、千兆，Non-PoE and PoE/PoE+，单通道、多通道, SMT 型、直 插 TH 型)之特性要求及测试方法。 This specification covers the requirements for product performance and test methods of LAN Transformer Modular (called Discrete Magnetics Modular), 10/100Base-T, Gigabit, Non-PoE and PoE/PoE+, SMT, Through hole, Single port or Multi Ports. 2. 标准文件 Applicable Standards 本规格部分内容来自下述标准文件。除非特别指明，否则下述标准文件均适用于最新版本。如本规格中 的要求与产品图纸发生矛盾，应当以产品图纸为准。如本规格中的要求与标准文件矛盾，应当以本规格 要求为准。 The following documents form a part of this specification to the extent specified herein. Unless otherwise specified, the latest edition of the document applies. In the event of conflict between the requirements of this specification and the product drawing, the product drawing shall take precedence. In the event of conflict between the requirements of this specification and the referenced documents, this specification shall take precedence. 2.1 自定义的测试程序Custom Test Procedures RJ45 集成磁性连接器的 LCR 参数说明及其通用测试指南 Test Procedure for LCR of RJ45 ICM RJ45 集成磁性连接器的耐压特性说明及其测试原则 Test Procedure for Dielectric Withstanding Voltage (Hi-pot) of RJ45 ICM RJ45 集成磁性连接器的网络特性说明及其通用测试指南 Introduction for High Frequency Networking performance of RJ45 ICM 网络产品 IL, RL, CROSSTALK, CMRR, CMA 等网络特性的测试指示 Test Procedure for IL, RL, Crosstalk, CMRR, CMA of RJ45 ICM （如需要以上文本，请网上搜索本人发行的资料或来信索取） 制订：饶利军 [Lee (Lijun) Rao] ljrao@ 初版时间：2005 年 6 月；修订时间：2011 年 9 月 10 日 页码 1 / 15 网络变压器模块可靠性测试规格书 10Sept.2011, Rev. B LAN TRANSFORMER MODULAR SPECIFICATION 2.2 工业